IMPROVEMENT OF CROSS SECTION OF COMPRESSED ELEMENTS BY TOPOLOGICAL RATIONALIZATION

Array

Authors

  • V. Shmukler O.M. Beketov National University of Urban Economy in Kharkiv
  • O. Lugchenko O.M. Beketov National University of Urban Economy in Kharkiv
  • А. Nazhem O.M. Beketov National University of Urban Economy in Kharkiv

Keywords:

deformation, energy, iteration, voids, cavity, rationalization

Abstract

The article describes the procedure of direct (rational) design of vertical compressed elements (columns, pylons, stiffening diaphragms, retaining walls). This technology is an exclusive modification of topological (bionic) rationalization. It is based on new energy principles and algorithms for sequential construction of geometric and / or physical-mechanical "image" of the structure. The example of the formation of energy-equivalent columns shows the sequence of computational operations of the method. The solution is built analytically in order to show the nuances of the necessary operations. At the same time, these examples show that the introduced optimization criteria in the form of en → const and U → inf U (here en is the value of the normalized density of potential deformation energy, and U is the potential energy of deformation) determine, including the minimum volume of constructs, as well as their minimum deflections. A fundamental element of the approach is the use of a new criterion of the limit state, which provides an estimate of the intensity of the element. In this case, the properties of the material and the type of stress-strain state are taken into account. The obtained analytical solution was used as a control test for the general computational procedure of the method. In this regard, the article presents the results of the analytical and numerical solution. The efficiency of the computational procedure is confirmed by the speed of its convergence and the minimum difference of geometric parameters (topology) of the structure with test examples. The technological sequence of computational operations of the method is completed by the construction of elements (pylons) with a simple external and complex internal geometry.

Author Biographies

V. Shmukler, O.M. Beketov National University of Urban Economy in Kharkiv

Dr. Sc. (Tech.), Professor  Department of building structures

O. Lugchenko, O.M. Beketov National University of Urban Economy in Kharkiv

Phd (Tech.), Associate Professor Department of building structures

А. Nazhem, O.M. Beketov National University of Urban Economy in Kharkiv

Post graduate student Department of building structures

References

1. V. Babaev, I. Ievzerov, S. Evel, A. Lantoukh-Liashchenko, V. Shevetovsky, O.Shimanovskyi, V.Shmukler, M.Sukhonos (2019). Rational Design of Structural Building Systems:Monografiya. Berlin / Germany: DOM publishers. ISBN 978-3-86922-733-7.
2. Shmukler V.S., Lugchenko O.I., & Nazhem A.Н. (2020). Chiselna verifikaciya odnogo pidhodu bionichnoyi racionalizaciyi konstrukcij. Zb. nauk. рr. Ukrayinskogo derzhavnogo universitetu zaliznichnogo transportu: Proceeding Scientific publication, 189,36-52.
3. Shenli F.R. (1957). Analiz vagi j micnosti litakovih konstrukcij: Moskva: Oborongiz.
4. Cobiax Technologies AG. Retrieved from: http://www.cobiax.com/startseite
5. AirDeck® System. Retrieved from: http://www.airdeck.com
6. BubbleDeck® System. Retrieved from: http://www.bubbledeck-uk.com
7. Zuo Z.H., Xie Y.M., & Huang X.(2009). Combining genetic algoritms with BESO for topology optimization. Structural and Multidisciplinary Optimization, 38(5), 511-523.
8. Tcherniak D. (2002). Topology optimization of resonating structures using SIMP method. International Journal of Numerical Methods Enginering, 54(11), 1605-1622.
9. Oganesyan P.A. & Shevcov S.N. (2014). Optimizaciya topologiyi konstrukcij u paketi ABAQUS. Zvistki Samarskogo naukovogo centru Rosijskoyi akademiyi nauk, 16, №6(2), 543-549
10. Ciarlet Ph. (1997). Mathematical elasticity / N.Y.: Elsevier
11. Clough R.W. & Bathe K.I. (1972). Finite element analysis of dynamic response. The Univ. of Alabama in Huntsville Press,6 , 153-159.
12. Shmukler V.S., Klimov Yu. A.& Burak N.P. (2008). Karkasni sistemi polegshenogo tipu: monografiya. Harkiv: Zoloty ctorinky
13. Vasilkov G.V.(2008). Evolyucijna teoriya zhittyevogo ciklu mehanichnih sistem. Teoriya sporudzhen: Navchalnyi posibnik. Moskva: Vidavnictvo LKI
14. Abovskyi N.P.(1978).Vibrani zavdannya po budivelnij mehanici j teoriyi pruzhnosti: Navchalnyi posibnik. Moskva: Nauka
15. Malinin N.N. (1968). Prikladnaya teoriya plastichnosti i polzuchesti: Navchalnyi posibnik. Moskva: Mashinostroenie
16. Gagauz F.M. (2005). Proektuvannya mnogolonzheronnogo krila z kompozicijnih materialiv. Aviacijno-kosmichna tehnika j tehnologiya, 2(18), 28-32.
17. Feodosev V.I. (1996). Vibrani zavdannya j pitannya z oporu materialiv. Navchalnyi posibnik. Moskva: Nauka

Downloads

Published

2020-09-30

How to Cite

Shmukler, V., Lugchenko, O., & Nazhem А. (2020). IMPROVEMENT OF CROSS SECTION OF COMPRESSED ELEMENTS BY TOPOLOGICAL RATIONALIZATION: Array. Municipal Economy of Cities, 4(157), 25–31. Retrieved from https://khg.kname.edu.ua/index.php/khg/article/view/5628

Issue

Vol. 4 No. 157 (2020): Series: Engineering science and architecture

Section

статьи

License

The authors who publish in this collection agree with the following terms:
• The authors reserve the right to authorship of their work and give the magazine the right to first publish this work under the terms of license CC BY-NC-ND 4.0 (with the Designation of Authorship - Non-Commercial - Without Derivatives 4.0 International), which allows others to freely distribute the published work with a mandatory reference to the authors of the original work and the first publication of the work in this magazine.
• Authors have the right to make independent extra-exclusive work agreements in the form in which they were published by this magazine (for example, posting work in an electronic repository of an institution or publishing as part of a monograph), provided that the link to the first publication of the work in this journal is maintained. .
• Journal policy allows and encourages the publication of manuscripts on the Internet (for example, in institutions' repositories or on personal websites), both before the publication of this manuscript and during its editorial work, as it contributes to the emergence of productive scientific discussion and positively affects the efficiency and dynamics of the citation of the published work (see The Effect of Open Access).